ATV12HU15M2

Telemecanique - Variable Speed Drives

Current response time:

By 5AM PT on Tuesday

Emergency?

*Santa Clara Systems is not a Telemecanique Authorized Distributor.

Description: Variable Speed Drives
Range of product: Altivar 12
IP degree of protection: IP20 without blanking plate on upper part
Width: 105 mm
Height: 142 mm
Depth: 156.2 mm
Operating altitude: > 1000...2000 m with current derating 1 % per 100 m
Tightening torque: 1.2 N.m
Vibration resistance: 1 gn (f = 13200 Hz) conforming to EN/IEC 60068-2-6
Shock resistance: 15 gn conforming to EN/IEC 60068-2-27 for 11 ms
Electrical connection: Terminal, clamping capacity: 5.5 mm, AWG 10 (L1, L2, L3, U, V, W, PA, PC)
motor power kW: 1.5 kW
[Us] rated supply voltage: 200...240 V - 15...10 %
Relative humidity: 595 % without condensation conforming to IEC 60068-2-3
Protection type: Line supply overvoltage
Switching frequency: 2...16 kHz adjustable
Product or component type: Variable speed drive
Product destination: Asynchronous motors
Product specific application: Simple machine
Assembly style: With heat sink
Component name: ATV12
Quantity per set: Set of 1
EMC filter: Integrated
Built-in fan: With
Network number of phases: 1 phase
Motor power hp: 2 hp
Communication port protocol: Modbus
Line current: 17.8 A at 200 V
Speed range: 120
Transient overtorque: 150170 % of nominal motor torque depending on drive rating and type of motor
Asynchronous motor control profile: Sensorless flux vector control
Noise level: 45 dB
Supply frequency: 50/60 Hz +/- 5 %
Connector type: 1 RJ45 (on front face) for Modbus
Physical interface: 2-wire RS 485 for Modbus
Transmission frame: RTU for Modbus
Transmission rate: 4800 bit/s
Number of addresses: 1247 for Modbus
Communication service: Read holding registers (03) 29 words
prospective line Isc: 1 kA
Continuous output current: 7.5 A at 4 kHz
Maximum transient current: 11.2 A for 60 s
Speed drive output frequency: 0.5400 Hz

Nominal switching frequency: 4 kHz
Braking torque: Up to 70 % of nominal motor torque without braking resistor
Motor slip compensation: Adjustable
Output voltage: 200...240 V 3 phases
Insulation: Electrical between power and control
Supply: Internal supply for reference potentiometer: 5 V DC (4.755.25 V), <10 mA, protection type: overload and short-circuit protection
Analogue input number: 1
Analogue input type: Configurable current AI1 0...20 mA 250 Ohm
Discrete input number: 4
Discrete input type: Programmable LI1...LI4 24 V 18...30 V
Discrete input logic: Negative logic (sink), > 16 V (state 0), < 10 V (state 1), input impedance 3.5 kOhm
Sampling duration: 20 ms, tolerance +/- 1 ms for logic input
Analogue output number: 1
Analogue output type: AO1 software-configurable voltage: 0...10 V, impedance: 470 Ohm, resolution 8 bits
Discrete output number: 2
Discrete output type: Logic output LO+, LO-
Minimum switching current: 5 mA at 24 V DC for logic relay
Maximum switching current: 2 A 250 V AC inductive cos phi = 0.4 L/R = 7 ms logic relay
Acceleration and deceleration ramps: U
Braking to standstill: By DC injection, <30 s
Frequency resolution: Analog input: converter A/D, 10 bits
Time constant: 20 ms +/- 1 ms for reference change
Marking: CE
Operating position: Vertical +/- 10 degree
Net weight: 1.4 kg
Functionality: Basic
Specific application: Commercial equipment
Variable speed drive application selection: Mixer Commercial equipment
Motor starter type: Variable speed drive
Electromagnetic compatibility: Electrical fast transient/burst immunity test level 4 conforming to EN/IEC 61000-4-4
Electromagnetic emission: Radiated emissions environment 1 category C2 conforming to EN/IEC 61800-3 2...16 kHz shielded motor cable
Product certifications: CSA
Ambient air temperature for storage: -2570 C
Ambient air temperature for operation: -1050 C protective cover from the top of the drive removed
Sustainable offer status: Green Premium product
REACh Regulation: REACh Declaration
EU RoHS Directive: Pro-active compliance (Product out of EU RoHS legal scope)
Mercury free: Yes
RoHS exemption information: Yes
China RoHS Regulation: China RoHS declaration
Environmental Disclosure: Product Environmental Profile
Circularity Profile: End of Life Information
WEEE: The product must be disposed on European Union markets following specific waste collection and never end up in rubbish bins

Santa Clara Systems specializes in hard-to-find parts. Choose from our overstock inventory and save on ATV12HU15M2 . Santa Clara Systems carries 10,296 items from Telemecanique.

We are in the process of adding data and downloadable material for this item. Please search similar items for more information related to this product.