General Electric

General Electric (GE) is an American multinational conglomerate corporation providing electrification and automation solutions to the petrochemical, mining & materials, utility and marine industries. GE industrial components includes programmable logic controllers, motor starters, servo drives, transformers, terminal blocks, and other similar products. GE markets their PLC and I/O components under the PACSystems RX3i, PACSystems RX7i, QuickPanel, DataPanel, PACMotion, Series 90-30/70, Series Six, and VersaMax product lines.

5,938

总目录

有现货

CR101JA1AStarter

General Electric

有现货

IC693 ALG 392High Density Analog Output

General Electric

Type of Device: High Density Analog Output (8 Channels)
Resolution: 4 to 20mA / 0 to 20mA / 0 to 10V / -10 to +10V
Output Current Range: 4 to 20 mA and 0 to 20 mA
Output Voltage Range: 0 to 10 V and ?10 V to +10 V
User Supply Voltage (nominal): +24 VDC, from user supplied voltage source

有现货

IC693 CMM 302Communications Module Genius GCM+

General Electric

Type of Device: Communication Module, Genius (1 Kbyte) GCM+ (No Datagrams support)
Product Description: Data monitoring by a personal computer or an industrial computer. Monitoring data from Genius I/O blocks (although it cannot control Genius I/O blocks).Peer-to-peer communications among devices on the bus. Master-slave communications among devices on the bus (emulates remote I/O).
UPC: 0755560496243
Status LEDs: OK - Shows the status of the GBC module. This LED turns on after power up diagnostics are completed. COM - Shows the status of the Genius communications bus. This LED is on steadily when the bus is operating properly. It blinks for intermittent bus errors and is off for a failed bus. It is also off when no configuration has been received from the PLC CPU.

有现货

IC697 ALG 230Analog Input Voltage/Current

General Electric

有现货

IC693 ALG 222Analog Input 16-PT

General Electric

Type of Device: Analog Voltage Input Module
Number of Channels: 1 to 16 selectable, single-ended / 1 to 8 selectable, differential
Input Current Ranges: 0V to +10V (unipolar) or ?10V to +10V (bipolar); selectable each channel
Calibration: Factory calibrated to: 2.5 mV per count on 0V to +10V (unipolar) range / 5 mV per count on ?10 to +10V (bipolar) range
Update Rate: 6 msec (all 16 single-ended channels) / 3 msec (all 8 differential channels)

有现货

F60-K03-VFH-F8L-H6L-MXX-PXXModule

General Electric

有现货

IC693 MDL 740Output Module

General Electric

Type of Device: Output Module
Output Current: 0.5 amps maximum per point
Rated Voltage: 12/24 volts DC
Output Voltage Range: 12 to 24 volts DC (+20%, ?15%)
Inrush Current: 4.78 amps for 10 ms

有现货

IC693 ALG 223Analog Input Module

General Electric

有现货

IC693 MDL 340Output Module | Series 90-30

General Electric

Type of Device: 120 Volt AC Output - 0.5 Amp, 16 Point
Product Description: The 120 volt, 0.5 Amp AC Output module provides 16 output points in two isolated groups with eight points in each group. Each group has a separate common associated with it (the two commons are not tied together inside the module). This allows each group to be used on different phases of the AC supply, or they can be powered from the same supply. Each group is protected with a 3 amp fuse, and an RC snubber is provided for each output to protect against transient electrical noise on the power line. This module provides a high-degree of inrush current which makes the outputs suitable for controlling a wide range of inductive and incandescent loads. AC Power to operate loads connected to outputs must be supplied by the user. This module requires an AC power source.
Output Current: 0.5 amp maximum per point, 3 amps maximum per group
Rated Voltage: 120 volts AC
Output Voltage Range: 85 to 132 volts AC, 50/60 Hz

有现货

TGK32Ground Bar Kit 32-Hole

General Electric

有现货

TC2368SMotor Switch

General Electric

有现货

CR101Y1Manual Starter

General Electric

Type of Device: Manual Motor Starter; NEMA Type 1, Single Phase, 1 Pole
Height: 2.75
Width: 2.50
Length: 4.25
Amperage: 16 A

有现货

IC693 BEM 331Genius Bus Controller

General Electric

Type of Device: The Series 90-30 Genius Bus Controller (GBC) (Supports I/O and Datagrams)
Genius Blocks: Provide an interface to a wide range of discrete, analog, and specialpurpose field devices
Remote Drops: Providing up to 128 bytes of input data and 128 bytes of output data
Field Control I/O Station: The BIU provides intelligent processing, I/O scanning, and feature configuration for the I/O station
Genius Hand-Held Monitor (HHM): HHM provides a convenient operator interface for block setup, data monitoring, and diagnostics

有现货

IC693 MDL 645Input Module | Series 90-30

General Electric

Type of Device: 24 Volt DC Positive/Negative Logic Input, 16 Point
Product Description: GE Fanuc Discrete input module for 90 - 30 series PLC has either positive logic or negative logic characteristics. It offers 16 input points in one group with a common power input terminal. Module has LED indicators at the top to offer ON/OFF status of each point. Module has circuit wiring information on the surface towards the inside and circuit identification information on the outside surface. Module can be conveniently installed in any I/O slot in a 90-30 series PLC system. It has a voltage rating 0 - 30 VDC, current rating of 7 milli-Amps, power rating of 80 milli-Amps at 5 VDC and 125 milli-Amps at 24 VDC. Module has a maximum ON/OFF response time of 7 milli-seconds. It is compatible with input devices such as pushbuttons, limit switches and electronic proximity switches. Input/output module provides the interface between the PLC and external input devices such as proximity sensors, push buttons, switches and BCD thumbwheels. It supports different voltage ranges, types, current capacity, isolation and response time to meet your application.
UPC: 004810000007
Response Time: 7 ms On/Off
Rated Voltage: 24 Volts DC

有现货

IC693 CBL 305PCM Communcations Cable

General Electric

Type of Device: Wye Cable for Series 90-30 ADC
Product Description: A Wye cable (IC693CBL305) is supplied with each Series 90-30 ADC module. The purpose of the Wye cable is to separate the two ports from a single physical connector, i.e., the cable separates the RS-232 from the RS-485 signals. In addition, the Wye cable makes cables used with the Series 90-70 ADC fully compatible with the Series 90-30 ADC. The Wye cable is one foot in length and has a right angle connector on one end that connects to the ADC module. On the other end, is a dual connector with one connector for port 1 and the other for port 2.

有现货

IC693 ACC 301 (BATTERY)Battery GE Fanuc

General Electric

有现货

IC670 MDL 640Input Module

General Electric

Voltage: 120 VAC
Input Impedance: 10K typical (reactive)
On state Current: 5 mA to 15 mA
On response time: 10ms typical, 20 ms maximum
Off response time: 20ms typical, 40 ms maximum

有现货

CR460XP32Power Block | 460XP32

General Electric

Type of Device: Lighting Contactor Power Pole Kit
Weight: 0.23 lbs
UPC Number: 078316662123

有现货

P9XPNGGPush Button Yellow

General Electric

有现货

CR306F002Starter | CR306 Size 4

General Electric

有现货

IC693 BEM 340Fip Controller Module

General Electric

Type of Device: Bus Controller (FBC) Module
Series 90-70 PLC: Interfaced to a FIP bus by a FIP Bus Controller
Field Control Stations: Field Control I/O modules that are interfaced to the bus via a FIP Bus Interface Unit (BIU).
Remote Drops: Series 90-30 I/O racks that are interfaced to the bus via FIP Remote I/O Scanner Modules. Each remote drop can include one 5- or 10-slot main rack, one 5- or 10-slot expansion rack and any mix of discrete and analog I/O modules.
Generic Devices: such as general-purpose computers that are interfaced to the bus via a FIP Interface Module.